About CALVE

CALVE · 2021-07-08

CALVE · 2019-11-27

CALVE · 2019-10-28

I use a STEVAL-IDB008V2 and connect sensor LPS22HB to it. By I2C bus , my program communicate with the sensor and it receve interrupt for end of pressure acquisition. The problem is that the pressure read is always equal to 0.0.

CALVE · 2019-09-05

Hi, I downloaded from my ST login the file "en.stsw-bluenrg1-dk.zip" and installed it. I don't found complete software directory structure as explain on "en.DM00298232.pdf" §6.1. Library, Project and Utilities folders are not present. Where can i dow...

CALVE · 2021-07-09

I modify the Nucleo board and now it run well. Thanks waclawek.

CALVE · 2019-10-31

Thanks. The problem is solved. Yes, as you can see in my program i check the WHO_AM_I code, and it was correct. The STEVAL-IDB008V2 implement another sensor on I2C bus (LPS25HB) with the same device address. Since i modified the address of LPS22HB, ...

User statistics

User Activity

Hi, I use NUCLEO-F303RE and i want to program 4 PWM: - TIM1-CH1 (PC0) : fail (no PWM signal) - TIM1-CH3 (PC2) : ok - TIM1-CH3 (PC3) : ok - TIM2-CH3 (PB10) : ok All PWM have same setup (RCY 50%). I test TIM1-CH2 (PC1) and no PWM on output.

I use a bluenrg2. Is existing a BLE_OTA_ServiceManager without all SDK calls?

Pressure of sensor LPS22HB always equal to 0.0

Library, Project and Utilities folders are not present in

Re: Hi, I use NUCLEO-F303RE and i want to program 4 PWM: - TIM1-CH1 (PC0) : fail (no PWM signal) - TIM1-CH3 (PC2) : ok - TIM1-CH3 (PC3) : ok - TIM2-CH3 (PB10) : ok All PWM have same setup (RCY 50%). I test TIM1-CH2 (PC1) and no PWM on output.

Re: Pressure of sensor LPS22HB always equal to 0.0