About RLind.3

RLind.3 · 2022-09-11

Hi there,I am using the STM32WLE4C8 and I am trying to write a safe handler for the NMI interrupt. From what I can tell, the NMI interrupt is triggered by a flash double ECC error, an HSE failure, or an SRAM parity error. All of these are fairly seri...

RLind.3 · 2022-09-06

Hi there,I am using an STM32WLE4C8 with FSK and I am trying to determine the offset between the internal carrier frequency and an incoming carrier frequency. This offset will be used to calibrate my device using a high accuracy incoming preamble and ...

RLind.3 · 2022-07-10

Hi there,I am using an STM32WLE and putting it into Standby mode for extended periods of time. I am trying to retain SRAM2 while in Standby mode, and it is working while the DBGMCU_CR_DBG_STANDBY bit is set. However, when I clear the bit SRAM2 is no ...

RLind.3 · 2022-06-08

Hi there,I am using an STM32WLE and I am trying to reduce my Standby mode current consumption. I am currently drawing around 800nA, while the datasheet says I should be drawing about 450nA. One potential cause of excess current is the LSI running for...

RLind.3 · 2022-06-01

Hi there,I am using an STM32WLE with an input voltage range of 2 - 3.3V. It will eventually be powered by a lithium coin cell, but I am currently using a benchtop power supply. The datasheet states that both the MCU and the radio should function down...

RLind.3 · 2022-09-07

Thanks Louis, this fixed my problem and I can now calibrate my device successfully! Thank you! :smiling_face_with_smiling_eyes:

RLind.3 · 2022-07-13

The problem has been resolved. It was an error in my linker, the address I had for SRAM2 was wrong. Fixing the address fixed the problem and my SRAM2 is now retained regardless of DBGMCU_CR_DBG_STANDBY.

RLind.3 · 2022-07-11

Hi Danish,When the MCU wakes, the PWR_EXTSCR_C1SBF is set, so I believe it is in Standby rather than Shutdown.Setting DBGMCU_CR_DBG_STANDBY maintains power to the core and keeps the processor clocks active. From the reference manual, "The STM32WLEx d...

RLind.3 · 2022-06-12

Hi Benoit,Thanks for your response. Could you please clarify the following points?Does the IWDG continue running through a Standby reset?Can I disable the LSI while the IWDG is running? What behaviour will this cause?Thanks,Rebecca

RLind.3 · 2022-06-01

Hi all,Turns out it was an issue between the seat and the steering wheel. I was looking at an updated schematic that used a pin for a different function, so my PU/PD resistors were set incorrectly. The MCU now enters and exits Standby mode correctly ...

User statistics

User Activity

STM32WL NMI Handler Best Practice

STM32WL CFO Registers

STM32WLE RAM Retention Only Functional in Debug Mode

STM32WLE - IWDG in Standby Mode

STM32WLE Standby Mode - Unresponsive at Low Voltages (<2.15V)

Re: STM32WL CFO Registers

Re: STM32WLE RAM Retention Only Functional in Debug Mode

Re: STM32WLE RAM Retention Only Functional in Debug Mode

Re: STM32WLE - IWDG in Standby Mode

Re: STM32WLE Standby Mode - Unresponsive at Low Voltages (<2.15V)