About EScha.1

EScha.1 · 2021-04-19

In the CubeIDE I have a simple program just to get familiar with the IDE. I have connected the STM32L476 and as the run / debug process starts I see the message below. When the console indicates debugger connected The LED on the ST-Ling part goes gr...

EScha.1 · 2021-04-21

Yes, debug is set for serial wire.

EScha.1 · 2021-04-20

When trying to download a program to the Nucleo and getting the message connection lost, is there any way to get a log of what was going on up to the failed connection? That might be helpful to diagnose the problem.

EScha.1 · 2021-04-20

Yes, I am using the USB connector on the ST-Link side of the Nucleo module. i also have the jumpers set for that connector and not the CN4 for SWD.I reviewed all the jumper settings even reviewing the schematics to be sure I understand their usage.It...

User statistics

User Activity

I have been trying to download a program to a Nucleo-STM32L476 and I always get the message debugger connected debugger connection lost

Re: I have been trying to download a program to a Nucleo-STM32L476 and I always get the message debugger connected debugger connection lost

Re: I have been trying to download a program to a Nucleo-STM32L476 and I always get the message debugger connected debugger connection lost

Re: I have been trying to download a program to a Nucleo-STM32L476 and I always get the message debugger connected debugger connection lost