Browse
STMicroelectronics Community
FAQs
Sign In
Product forums
STM32 MCUs
STM32 MCUs Products
STM32 MCUs Boards and hardware tools
STM32 MCUs Software development tools
STM32 MCUs Embedded software
STM32 MCUs TouchGFX and GUI
STM32 MCUs Motor control
STM32 MCUs Security
STM32 MCUs Wireless
STM32 MPUs
STM32 MPUs Products
STM32 MPUs Boards and hardware tools
STM32 MPUs Embedded software and solutions
STM32 MPUs Software development tools
MEMS and sensors
MEMS (sensors)
Imaging (sensors)
Automotive and Transportation
Automotive MCUs
AutoDevKit Ecosystem
GNSS positioning
Edge AI
Interface and connectivity ICs
Power management
ST25 NFC/RFID tags and readers
STM8 MCUs
Others: hardware and software
Analog and audio
Knowledge base
STM32 MCUs
STM32 MPUs
MEMS and sensors
Analog and audio
EMI filtering and signal conditioning
Interface and connectivity ICs
Power management
Quality & reliability
Academy
About
Community guidelines
Feedback forum
Community blog
Developer news
sG.12
Associate II
since
2019-01-22
2023-06-14
User statistics
7
Posts
0
Solutions
0
Kudos given
0
Kudos received
STMicroelectronics Community
About sG.12
Options
Report User
User Activity
Posts
Replies
USART not working while enabling Watch dog timer(WWDG) in stm32f105RB.
2019-02-11
I'm Working on CAN protocol. Its worked good in loopback mode . but while executing in normal mode it will show dominant bit error.
2019-01-22
using STM32f103c8t6 and transceiver MCP2551. This transceiver working well in with other controllers.
Re: USART not working while enabling Watch dog timer(WWDG) in stm32f105RB.
2019-02-11
ok.. we will check.. Thank you so much..
Re: USART not working while enabling Watch dog timer(WWDG) in stm32f105RB.
2019-02-11
#include "main.h" #include "stm32f1xx_hal.h" CAN_HandleTypeDef hcan1; WWDG_HandleTypeDef hwwdg; UART_HandleTypeDef huart1; static CanTxMsgTypeDef myTxMessage; static CanRxMsgTypeDef myRxMessage; static CAN_FilterConfTypeDef myFilter; ...
Re: I'm Working on CAN protocol. Its worked good in loopback mode . but while executing in normal mode it will show dominant bit error.
2019-02-11
Crystal based. 8Mhz
Re: I'm Working on CAN protocol. Its worked good in loopback mode . but while executing in normal mode it will show dominant bit error.
2019-02-11
only checked using ST LINK debugger.
Re: I'm Working on CAN protocol. Its worked good in loopback mode . but while executing in normal mode it will show dominant bit error.
2019-01-22
already checked everthing..speed 1Mhz, terminate with 120 ohm
