About MartinSMG

MartinSMG · 2021-03-27

Hi,I am running into some problems with generating new code for my MCU (STM32G474RBT6).I have installed STM32CubeIDE v1.6.0 and FW pack v1.4.0.I have created my entire pinout with a correct setup (my friend checked it and he is working with these MCU...

MartinSMG · 2021-04-05

Finally I can say that everything is working fine now. At first it was probably caused by something during code generation ans now it is everything working fine, at last point it was caused by my oscilator.

MartinSMG · 2021-04-04

I have added here some new points. My friend is telling me that it could be caused by the fact that it is the new model of MCU and there might be some bugs in generating code in IDE. I honestly do not know. But last code which should at least act as ...

MartinSMG · 2021-04-02

Honestly I am starting to be lost. Newly generated code which finaly contains every important part is not working. A have added into it just stupid LED blinking but after powering board up nothing happens. I have tried connecting a debugger into it w...

MartinSMG · 2021-04-01

Well, today I have tried it again and regenerated entire code based on .ioc file and now I have even middleware folder there.

MartinSMG · 2021-04-01

I do not know if it matters but here is the fixed project, in first archive there are some errors in my code.

User statistics

User Activity

Problem with generating code for STM32G474RBT6.

Re: Problem with generating code for STM32G474RBT6.

Re: Problem with generating code for STM32G474RBT6.

Re: Problem with generating code for STM32G474RBT6.

Re: Problem with generating code for STM32G474RBT6.

Re: Problem with generating code for STM32G474RBT6.