About RKage.3

RKage.3 · 2021-02-23

I am running both SDADCs on a STM32373C-EVAL evaluation board. One of them is giving me the correct values from 0-65.535 but the second one is giving me 0-32.767 on the same voltage.I have configured them using the Cube IDE and Hal. They are set up e...

RKage.3 · 2021-02-17

I have been reading reading anything i could find on Timers, but I'm still confused about the setup in CubeMx.I just want to trigger a timer in software, that generates a SINGLE pulse with a set width (and if possible after a set dely) on a pin, but ...

RKage.3 · 2021-02-17

Ok, I have found the answer myself.Here is the setup: (every setting i don't mention is either disabled or in it's standard state)Clock Source: Internal clockChannelx PWM Generation Channelx (if set to Output compare, it won't reset after the timer i...

User statistics

User Activity

16 Bit SDADC is only giving 15 Bit value

Generate Single pulse using timer using HAL / CubeMx

Re: Generate Single pulse using timer using HAL / CubeMx