About RGord

RGord · 2023-03-20

I am working on a custom board with a BlueNRG-345 microcontroller, with the BlueNRG-LP Development kit 1.2.0 and using WiSE Studio as the development environment. I have taken the BLE Beacon project for the STEVAL-IDB011V1 and converted it to run on...

RGord · 2023-04-25

Hi LaurentIt turns out that our hardware guys had spotted the C24 cap/coil error already as without this change the board would not work at all. They have now changed cap C32 to 220nF and this cures the problem I was having with the firmware going i...

RGord · 2023-04-05

Hi LaurentThanks for speedy response. I've passed this information on to our hardware engineer and hopefully this will solve our problem.Kind regardsRob

RGord · 2023-04-05

Hi LaurentThanks for responding.Use LSIThe board does not have an LSE so I am already using LSI by building with CONFIG_HW_LS_RO. (There is a typo in my original post.)Increase HSE start up timeI think I tried this before but I have tried it again a...

RGord · 2022-05-13

Did you ever solve this problem of being unable to debug if you allow it to run?I had the same problem with some of the BLE examples, but not with the peripheral examples.For me the problem was caused by the processor going into power saving modes so...

User statistics

User Activity

BlueNRG-345 custom board repeatedly resets due to Hardware_Code = 0x01

Re: BlueNRG-345 custom board repeatedly resets due to Hardware_Code = 0x01

Re: BlueNRG-345 custom board repeatedly resets due to Hardware_Code = 0x01

Re: BlueNRG-345 custom board repeatedly resets due to Hardware_Code = 0x01

Re: BlueNRG-LP and WISE Studio, unable to debug STEVAL-IDB011V1