This is not a question then an information for NUCLEO STM32H7 (or others...) users: After searching so many hours inside the software today i found the reason for malfunction: Jumpers JP6 & JP7 was well closed (optical impression), but gave no stabl...

Hi again, Issues around the ETH-Peripheral of the H743 are not addressed for the first time here. It would be extremely helpful to have one example (simple as possible) with a kind of "guarantee" to run on a NUCLEO 743 Board "out of the box". This c...

After spending a lot of time, ethernet examples still not running on the NUCLEO 743 Board. MPU Config is done correctly (at least i think so, it's the recommended code), IO-config for PHY checked 100times, map-file was compared for used ram-locations...

Hi,My Question is related to the PHY LAN8742 mounted on that board. GPIO Configuration for this part is OK, but obvioulsly the 25Mhc clock generator is not working, and i guess this is the reasonfor no response from the PHY. I expect a 25Mhc signal...

STM32H743: errata sheet reports a bug by using both CAN-Interfaces (CANFD), is this bugstill valid for currently manufactured silicon or fixed ?