About H.Darwish

H.Darwish · 2019-03-09

Hello I am using stm32f030f4 and i want to use the STM32Cubeprogrammer in automatic mode , i had tried to use –ob rdp=1 to change the read out protection level to 1 ,but its not working .what is the right option bytes command?

H.Darwish · 2018-10-25

hii am trying to make a new project on STM32F030K6 but, after i start and pause debug, a message appears : The stack pointer for stack 'CSTACK' (currently 0x20000658) is outside the stack range (0x20000048 to 0x20000448) . and the program stuck so...

H.Darwish · 2018-09-23

hello i am using stm32f103 for reading a 10 adc channels and i am using Dual mode regular simultaneous with DMA , the result are loaded in a buffer.the problem is the loaded data from the ADC1 are in the right order (1st data is from 1st channel)bu...

H.Darwish · 2018-09-22

H.Darwish · 2018-10-25

HIi had found the problem , in my pcb design i was pulling the Boot 0 pin to VCC , so the program was booting from the system memory not from the main flash memory .i had connected the boot 0 to vss and unchecked the boot1 in option bytes , and the p...

H.Darwish · 2018-10-25

Thank you for you quick reply >>Any routines using more than 1KB of local/auto variables? i dont think so ,i am just using one function in my code :HAL_GPIO_TogglePin>>Check what startup.s is setting the initial stack pointer too, or if it is changin...

H.Darwish · 2018-09-24

thanks for your help AvaTAr , but still not having solution :)the result sampled from adc1 are loaded in correct order in the buffer , but the result from adc2 are not .i dont know why , maybe some ovelapping , as i know the adc data of ADC1 and ADC...

H.Darwish · 2018-09-23

i had tried also to print the values to treminal ,same result.its really strange the values sampled by the adc1 are in right sequence , and the samples from the adc2 are not.the steps that i am doing is :in main function : 1-HAL_ADC_Start(&hadc2); 2-...

H.Darwish · 2018-09-23

>>>How are you inspecting/logging this data?the adc buffer in initialized as volatile uint16_t monitored using st-link debugger.

User statistics

User Activity

what is the option bytes commands to make the RDP level to 1?

STM32F030K6 stack problem

the adc result in dual mode are not in the right order

the result of ADC1 and ADC2 with DMA are not in right order

Re: STM32F030K6 stack problem

Re: STM32F030K6 stack problem

Re: the adc result in dual mode are not in the right order

Re: the adc result in dual mode are not in the right order

Re: the adc result in dual mode are not in the right order