About RRobi.1

RRobi.1 · 2020-12-17

I am able to set pins (high/low) that I have specified to be GPIO_Output in the Pinout& Configuration tab of the .ioc file. Using the code written below (changing the pin number) I am able to observe the expected behaviour on a oscilloscope using all...

RRobi.1 · 2020-12-17

Ahh I think this may be it. I see that PA2 and PA3 are set up the USART2 interface with default setup of the solder bridges and need to be changed if these pins are needed for something else. Thanks very much

RRobi.1 · 2020-12-17

Hi there, Thank you for your response. I realise the .ioc file I had sent you did not have the PA pins configured to GPIO_Output. I was testing all the PA pins in batches and so had reset the lower number pins when testing the higher numbers which is...

RRobi.1 · 2020-12-17

I have now attached the .ioc to the question. Note only the last few PA pins are set to GPIO_Output ( I was testing them in batches)

User statistics

User Activity

Setting specific GPIO_Output pins high/low

Re: Setting specific GPIO_Output pins high/low

Re: Setting specific GPIO_Output pins high/low

Re: Setting specific GPIO_Output pins high/low