About KRem.1

KRem.1 · 2020-12-08

I use these fonction to enable all three channels: HAL_TIM_OnePulse_Start(&htim3, TIM_CHANNEL_1); HAL_TIM_OnePulse_Start(&htim3, TIM_CHANNEL_2); HAL_TIM_OnePulse_Start(&htim3, TIM_CHANNEL_3);it have to insert this to enable ch3 but just for the chann...

KRem.1 · 2020-12-13

Hi, I finally get my timer working as I wish. I went directly programming the register. In my case, I use the timer 1 to trigger the timer 3 (one pulse mode) on the microcontroler as i needed so extra feature from the timer 1 (the repetition counter)...

KRem.1 · 2020-12-08

ok, thank you.I may have to adapt this function.

KRem.1 · 2020-12-08

Stm32f103rb, the nucleo board

User statistics

User Activity

Hi, I wanted to use three channel on a single timer. The setup seems to work fine for the first two (ch1 and ch2) but not for ch3. it seems that even with HAL I have to manually set the bit TIM_CCER_CC3E on for ch3. Did I miss something?

Re: Hi, I wanted to use three channel on a single timer. The setup seems to work fine for the first two (ch1 and ch2) but not for ch3. it seems that even with HAL I have to manually set the bit TIM_CCER_CC3E on for ch3. Did I miss something?

Re: Hi, I wanted to use three channel on a single timer. The setup seems to work fine for the first two (ch1 and ch2) but not for ch3. it seems that even with HAL I have to manually set the bit TIM_CCER_CC3E on for ch3. Did I miss something?

Re: Hi, I wanted to use three channel on a single timer. The setup seems to work fine for the first two (ch1 and ch2) but not for ch3. it seems that even with HAL I have to manually set the bit TIM_CCER_CC3E on for ch3. Did I miss something?