About G. Michael

G. Michael · 2021-04-15

Hello,I tried using the $PSTMNMEAREQUEST command setting only the bits for the 3 messages but I am still getting the periodic messages.Thanks in Advance!

G. Michael · 2020-12-06

Good Evening,I am an STM user, I used it for a lot of project and I am familiar with it.Now I am trying to start a Drone project and I have the STEVAL-ESC001V1 Controller (Link bellow). When I tried using the motor profiler or even the STM Workbench ...

G. Michael · 2021-04-16

Thank you for your help,I adjusted the buffer and the messages are not being Cut randomly.I solved the issue with the specific messages using the $PSTMCFGMSGL instead of $PSTMNMEAREQUEST.I have a question though. I want to extract the vertical distan...

G. Michael · 2021-04-15

Yes, the device is definitely responsive because it prints my requests and other data as seen in the photos below. Wiring, UART and checksumm are I suppose and CR,LF also present.For checksumm I am using an online NMEA checksumm calculator.Commands i...

User statistics

User Activity

Using AEK-COM-GNSST31 board with the Teseo Liv3f GPS on. I have successfully accessed the data from the gps but I want to recieve only $GPGGA, $GPGLL and $GPRMC messages. How do I do this ?

Issue with ESC001V1

Re: Using AEK-COM-GNSST31 board with the Teseo Liv3f GPS on. I have successfully accessed the data from the gps but I want to recieve only $GPGGA, $GPGLL and $GPRMC messages. How do I do this ?

Re: Using AEK-COM-GNSST31 board with the Teseo Liv3f GPS on. I have successfully accessed the data from the gps but I want to recieve only $GPGGA, $GPGLL and $GPRMC messages. How do I do this ?