About tdarlic

tdarlic · 2019-01-18

Hi guysI am bringing up a small test board containing a STM32F042 MCU with just several connections.I have exported code from CubeMX5 and imported into Eclipse. I am trying to debug the board with j-link but according to debugger code loops infinitel...

tdarlic · 2018-12-10

I was searching for smaller and cheaper MCU with CAN network. I have chosen the STM32F042F4P6 trough CubeMX but now when I try to enable CAN in CubeMX I cannot because it's grayed. What am I doing wrong?

tdarlic · 2019-01-18

Just to update. I struggled to change the option bytes on the jlink or directly from Eclipse. I failed so installed ST-LINK on a windows virtual machine bcause I develop on Linux. I do not have ST-LINK hardware here so I used Nucleo board ST-LINK par...

tdarlic · 2019-01-18

Thanks for that idea. It seems to me that I boot from system memory. I did not see the boot pin in the CubeMX so I just thought that I don't have one. I found this in the reference manual:In the STM32F0xx, three different boot modes can be selected t...

tdarlic · 2018-12-10

I found it.You need to swap the pins under SYS: "Pins PA11/12 instead of pins PA9/10"Answer is also in question belowhttps://community.st.com/s/question/0D50X00009sWUBjSAO/use-can-in-stm32f042f4-can-not-config-in-cubemx

User statistics

User Activity

STM32F042F4P6 does not enter main()?

How to enable CAN on STM32F042F4P6 CubeMX?

Re: STM32F042F4P6 does not enter main()?

Re: STM32F042F4P6 does not enter main()?

Re: How to enable CAN on STM32F042F4P6 CubeMX?