About Touftoufe

Touftoufe · 2021-04-23

Hello !Hope you're all doing well.I have a little problem here, my CAN BUS Tx is not working on "Normal Mode"I have a bus with several nodes communicating between them without any problem, so the bus itself is not the problemIn "Loopback mode" it wor...

Touftoufe · 2021-02-07

Hello !I'm actually using an STM32H745 dual Core with touchGFX and CubeIDE. I know that the dual cores aren't supported yet, but I kind of love challenges.So I managed to make it work using :Partial BufferCustom drivers (FMC)no hardware acceleration ...

Touftoufe · 2020-10-25

Hi everyone,I am a student and I am working on a project involving an STM32f429ZI and a 7inch touch display.It's the first time I work with displays, I am trying to create a GUI using touchgfx.I have been working on it for a week now and so far I man...

Touftoufe · 2021-04-30

In the end it was a voltage level issue with the transceiver standby pin. Every thing works fine now

Touftoufe · 2021-04-24

I have a bus analyser to receive and transmit frames and an oscilloscope to monitor the signals.In the beginning, I can see that the stm32 tries to send a frame using the scope, the Tx is pulled low then immediately goes high and then nothing. In thi...

Touftoufe · 2021-02-07

I don't know, I already used DMA2D with FMC on a stm32F429 and it works perfectly

Touftoufe · 2020-10-26

Hello,I tried to look every where in my code and I didn't found any thing that could explain that behavior, so I decided to create a new clean project and guess what? Every thing works fine. I don't know what detail I missed in my previous code, I wo...

Touftoufe · 2020-10-26

Thank you.Well, as I said, the touch seems to be detected because we can see the button being pressed and released every time I click.(And when I start the debugger, all works fine, the coordinates are correct and the callback is called. But when th...

User statistics

User Activity

CAN BUS Tx not working in Normal mode

Black screen when using DMA2D on Touchgfx

The button pressed animation is displayed but the callback is not executed every time the button is clicked

Re: CAN BUS Tx not working in Normal mode

Re: CAN BUS Tx not working in Normal mode

Re: Black screen when using DMA2D on Touchgfx

Re: The button pressed animation is displayed but the callback is not executed every time the button is clicked

Re: The button pressed animation is displayed but the callback is not executed every time the button is clicked