Hi,is there a way to program a STM32 Nucleo board (Nucleo-F767ZI) via the Ethernet interface?The problem with the usb port is when the Nucleo 5V is powered externally via the E5V pin, at power on of the 5V, the usb cable must be removed. So on a remo...

Posted on February 08, 2018 at 11:43Hi,for a new project I have to transfer data from a SD card to a serial line SDI (1 GPIO line). The data has to be synchronized with a 20 Mhz clock CK. At certain times , controlled by an external encoder signal, ...