About DNiet.1

DNiet.1 · 2021-01-03

To my current knowledge, the latest version of STMCUFinder (3.1.0, MacOS) does not include a selectable column (and/or Peripheral on the left) to select FDCAN.Also, it does not appear that FDCAN is 'implied' by the CAN peripheral. For example, the p...

DNiet.1 · 2023-01-07

Dear ST,Are there any plans to support MacOS in the foreseeable future?(as it is, I am unable to use it, as it also doesn't work with CrossOver)Regards

DNiet.1 · 2021-10-25

Sorry for the late response - such is life when you have a full-time job and just bought a house...@Community member : With "Stop DMA" I meant using the HAL function: ç(&htim1, TIM_CHANNEL_2); (for my particular config).After this, I wanted the pin ...

DNiet.1 · 2021-10-15

Dear @NSR ,Hoping to resurrect the thread enough for you to answer: did you solve the issue?I have the exact same issue (but the other way around: TIM1 CH2 PWM goes high after I stop PWM DMA, and I want to have it low; setting internal pull-down doe...

DNiet.1 · 2021-01-04

Thanks for the additional pointers.I will do as you requested.

DNiet.1 · 2021-01-04

@TDK: Don't know why my "About" screen showed "2021" in the version info, but indeed it was a very old version (verified it on an older laptop of mine).I retested this on another machine, updating to 6.1.1 and I can indeed reproduce your behaviour ...

User statistics

User Activity

How to use STMCUFinder to find MCUs supporting CAN-FD (FDCAN peripheral)

Re: Does X-CUBE-MCSDK support macOS?

Re: Configuring Idle State for Timers

Re: Configuring Idle State for Timers

Re: How to use STMCUFinder to find MCUs supporting CAN-FD (FDCAN peripheral)

Re: How to use STMCUFinder to find MCUs supporting CAN-FD (FDCAN peripheral)