About csotiriou

csotiriou · 2021-03-10

I'm looking to use the STM32F767 as part of a motor driver. However, it is not available under the MCU list in the tool. Why is that so? Is there a way to use the tool with that MCU?

csotiriou · 2021-02-27

I'm using the Nucleo-H743ZI STM32 development board on windows 10. When I upload a program that sends out data through CDC with CDC_Transmit_FS and open a serial monitor right after, it works fine. But when I disconnect and reconnect the Nucleo to my...

csotiriou · 2020-12-09

Using STM32CubeIDE.Also when defined by user the autocomplete does not work on the IDE for those functions

csotiriou · 2021-02-27

I found a fix in the following thread, in the answer from @Ant M https://community.st.com/s/question/0D50X00009Xke3ESAR/usb-vcp-windows-10

csotiriou · 2020-12-09

Even after I define CAN1 (and the IDE shows them as not gray (active)) they still don't show in the autocomplete. The project compiles even without the define.

User statistics

User Activity

STM32F767 Motor Control Workbench. Why is it not available by default? Is there a way to configure the tool for that device?

USB CDC does not work when I unplug and replug STM32

In the HAL files why does #if defined(CAN1) exist and why is it not defined by default if I enable CAN1.

Re: USB CDC does not work when I unplug and replug STM32

Re: In the HAL files why does #if defined(CAN1) exist and why is it not defined by default if I enable CAN1.