About Nidhal Ben Othmen

Nidhal Ben Othmen · 2021-05-04

Hello,I am using an STM32F103RB MCU in a specific Hardware design.The Hardware was always working fine (it is a final product of medical customer) until I flashed a software which implements the stop mode (deep sleep mode) management (by setting the ...

Nidhal Ben Othmen · 2017-10-11

Posted on October 11, 2017 at 11:08Hi everybody,I am working with the evaluation board B-L072Z-LRWAN1 with I-CUBE-LRWAN embedded software. I am trying to customize the received frame from the LoRaWAN network. I am working in France 868 MHz with the ...

Nidhal Ben Othmen · 2021-05-06

Thank you Mohamed and Tesla for your answers.Actually, I resolved the issue! The problem is the NRST of the MCU is not connected to the RESET pin of the J-Link connector.Connecting that, works well and I can flash the MCU with no problem.

Nidhal Ben Othmen · 2021-05-06

Hello @Mohamed Aymen HZAMI ,Thanks for your answer. But, this can be doable if I can program my MCU. Now, I can do nothing since the programmer can't access to the MCU.

User statistics

User Activity

STM32F103RB: Connecting to CPU via connect under reset failed after flashing a stop mode manager software

No LoRa received message from the backend

Re: STM32F103RB: Connecting to CPU via connect under reset failed after flashing a stop mode manager software

Re: STM32F103RB: Connecting to CPU via connect under reset failed after flashing a stop mode manager software