FAQs
TYomo
Associate II
since ‎2020-10-01
‎2023-06-14

User statistics

  • 14 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

VL53L1 can measure the target within 8 meters. However, the VL53L1_Gui(api rev 2432 6.6 build 1) showed "NOT VALID" even if the target stood at about 3 meters.

2021-03-31
I was evaluating VL53L1 through X-NUCLEO-53L1A2.The GUI (api rev 2432 6.6 build 1) showed NOT VALID, but I checked the Data Log (.csv) and I found the "trueRange_cm" data was valid. I have a question, which data result is true, GUI or Data Log?Thanks...

X-NUCLEO-53L1A2 board doesn't work with VL53L1_GUI. Center is no problem, but other sides (not only LEFT but also RIGHT) didn't work. I purchased two connectors (2x5 box) and soldered them on the board. I connected breakout boards to LEFT and RIGHT.

2021-03-26
If I selected CENTER, the measurement started well. But if I selected LEFT or RIGHT, the measurement seemed to be stopped even though start button was pushed. Is it bug?

Are not there connectors on X-NUCLEO-53L1A2?

2021-02-18
Hi!I purchased X-NUCLEO-53L1A2 and tried to check the function.However it was impossible to connect VL53L1 breakout board through left and right connectors.Because there were not left and right connectors. I attached the picture. But about X-NUCLEO...

VL53L1-SATEL circuits question

2021-02-01
Dear a ST engineer,​I had purchased VL53L1-SATEL and evaluated the function with NUCLEO-F401RE and "VL53L1 Gui". I connected VL53L1-SATEL board to NUCLEO-F401RE board directly through some wires.However the GUI didn't recognize the connection of VL53...

Is it wrong that AN5561 shows the distance mode?

2021-01-18
I have a question;Recently, I got the sample of VL53L3CX and evaluated the spec with GUI​(STSW-IMG016).According to the AN5561, VL53L3CX seems to have the 3 modes, "Short", "Medium" and "Long".However, I couldn't find the mode option on the GUI.Then ...
View more
Top