About GMcPh.1

GMcPh.1 · 2023-01-20

I created a very simple GUI in TouchGFX and generated the code. I then opened the .ioc file in ST32CubeMX and generated the code for each different IDE. The code works in STM32CubeIDE but fails for both EWARM and uVision. Obviously generating the cod...

GMcPh.1 · 2020-09-28

I am using the standard VL6180 Breakout Board from ST connected to a pyboard running micropython.For my application I need a range at least up to 200mm using multiple reflective surfaces from reflective to not so reflective. I have managed to get the...

GMcPh.1 · 2023-01-23

Hello Osman,Thank you for your reply. I followed the STM32 Graphics: How to use IAR EWARM with TouchGFX templates - YouTube video and managed to build the project just fine. The problem I now have is in uploading the code to the development board. I'...

GMcPh.1 · 2023-01-20

Hi,Thanks for the suggestion. I've tried following your method and although it appears to build, it still has an error which could well be due to some setting I have incorrect in CubeMX.The error is now: Error[Lp011]: section placement failed u...

GMcPh.1 · 2020-10-07

Thanks John,I have definitely run into the problem of the target not being large enough in the actual application. As such we have reverted to the older mechanical design which places the targets at 10cm.I have bought both the VL53L0X and VL53L1X sat...

User statistics

User Activity

How to fix build errors in IAR EWARM V9.32.1 and/ or Keil uVision V5.38.0.0 for TouchGFX projects V4.21.1 and STM32CubeMX V6.7.0 ?

VL6180 register setup for use with cover filter

Re: How to fix build errors in IAR EWARM V9.32.1 and/ or Keil uVision V5.38.0.0 for TouchGFX projects V4.21.1 and STM32CubeMX V6.7.0 ?

Re: How to fix build errors in IAR EWARM V9.32.1 and/ or Keil uVision V5.38.0.0 for TouchGFX projects V4.21.1 and STM32CubeMX V6.7.0 ?

Re: VL6180 register setup for use with cover filter