Posted on July 02, 2015 at 12:21Reading the reference manual RM0385 (DocID026670 Rev 1) in the introduction to the DCMI on p. 478 I encountered this: ''[...] This interface is also able to transmit a parallel data flow, allowing it to emulate a came...

Posted on November 12, 2014 at 19:08I'm planning to use the FSMC to memory-map registers of a FPGA. To save pins I would like to use multiplexing between data and address lines. Now, I need only a 8-bit data bus width but would like to address more ...

Posted on October 30, 2014 at 10:45The title says ist all - is there a recommended land pattern for the STM32 UFBGA176+25 package (0.8 pitch)? Can someone share their experience with low-cost prototyping shops like PCB-Pool? #stm32-land-pattern-l...

Posted on January 16, 2013 at 10:06Hi, our institute is currently using STM32F103 devices in a distributed control system. However we are evaluating a switch-over to STM32F40x devices for the sake of its FPU and higher clock speed at comparable cur...

Posted on January 23, 2012 at 11:42Hi there, I am implementing a emulated EEPROM in flash memory on a STM32 microprocessor, mostly based on the Application Note by ST (AN2594 - EEPROM emulation in STM32F10x microcontrollers). The basics outline the...