About peter__

peter__ · 2019-12-05

I freshly installed STM32CubeIDE (with J-LINK and ST-LINK selected during install) and created a new projekt. When trying to create a debug configuration Segger J-LINK is not selectable as debug adapter - only ST-Link.Tried on Windows and Linux.Also ...

peter__ · 2019-12-05

OK - I'm using an STM32H7 indeed .. but a single-core version.Would be great if JLINK support was added for these MCUs.

peter__ · 2018-05-08

Posted on May 08, 2018 at 16:15Can't you make your code (or relevant sections / files) available? A binary would be problematic, as i use a custom hardware (which needs a lot of pin initialization and toggling to be workable with).

peter__ · 2018-05-08

Posted on May 08, 2018 at 08:41Is you test-code working with the 1B transfer from your code below? 4B would be more realistic.What divider/frequency do you use?Would you care to share your whole project code? Would be interesting, if your code fails...

peter__ · 2018-04-09

Posted on April 09, 2018 at 08:59Thank you for the answer!Is there code that is powering down the peripherals/pins?No.Can you dump out the SDIO peripheral registers either side of the failing condition?As I mentioned, I cannot reproduce the issue du...

peter__ · 2018-04-04

Posted on April 04, 2018 at 12:44I experience the same problem in the same setup.It happened after moving to the new F4 HAL 1.19.0 from 1.16.0 (a new SDIO lib was introduced).Everything works as expected, even under high load .. until you let it sit...

User statistics

User Activity

STM32CubeIDE 1.1.0 does not offer Segger J-LINK debug probe in debug configurations

Re: STM32CubeIDE 1.1.0 does not offer Segger J-LINK debug probe in debug configurations

Re: SDIO(FatFS) File open(write) problem

Re: SDIO(FatFS) File open(write) problem

Re: SDIO(FatFS) File open(write) problem

Re: SDIO(FatFS) File open(write) problem