About Nick Faughey

Nick Faughey · 2020-09-02

I'm trying to debug the default X-CUBE-AWS application on the B-L4S5I-IOT01 dev board, but when I launch the debug configuration in STM32CubeIDE, I get the following error:Break at address "0x80209d8" with no debug information available, or outside o...

Nick Faughey · 2020-08-20

I'm trying to run the aws_demos project from X-CUBE-AWS on the B-L4S5I-IOT01A development board. I've successfully programmed and run the provisioning image. I've successfully built the aws_demos project, and have the "B-L4S5I-IOT01_aws_demos.sfb" an...

Nick Faughey · 2020-08-21

It turns out that a full chip erase via STM32CubeProgrammer, followed by a hard boot (power unplugged), followed by reflashing the application, resolves this for both of my units. I haven't been able to reproduce - perhaps something setting was shipp...

Nick Faughey · 2020-08-21

The watchdog reset here is just a symptom of the issue - disabling the watchdog still makes the program hang. Adding a configPRINTF() just after initializing UART in the main() function confirms that the application is at least not making it to there...

User statistics

User Activity

Debugging X-CUBE-AWS issues on STM32CubeIDE

X-CUBE-AWS demo project on B-L4S5I-IOT01A does not run

Re: X-CUBE-AWS demo project on B-L4S5I-IOT01A does not run

Re: X-CUBE-AWS demo project on B-L4S5I-IOT01A does not run