About PRaji.1

PRaji.1 · 2020-05-13

We are in middle of our Production process and we are using your LSM6DS3USTR. Here are the setup we have :1. combo mode (i.e Accel+gyro) 2. ODR = Accel(26Hz) and Gyro(26Hz). 3. Input power supply = 1.8V Currently, we are seeing a constant current pul...

PRaji.1 · 2020-06-02

Hi Eleon, Just to update on this. As you suggested, We have connected SDx to SCx to GND and we are still seeing the high current peak at every 38ms. Would it possible for your team to replicate the issue. Our current setup we have is :1. combo mode (...

PRaji.1 · 2020-05-21

HI Eleon ,Just to make clear on the above, We are using FIFO mode . So we arent reading the data through SPI for every 38ms. We are only reading data through SPI, only at every 1.2s. ThanksPrakash Rajiah

PRaji.1 · 2020-05-15

Hi Eleon, Thanks for getting back to me. Yeah we use SPI Protocol. The SPI Communcation speed is at 8MHz (Works well for all other ST Chips). Yeah, we are bit concerned about measures there because, the 1.392mA for every 38ms and 460uA is draining o...

User statistics

User Activity

Hello Team, We would like to confirm the current consumption of the LSM6DS3USTR while enabling the Accel+ Gyro Mode.

Re: Hello Team, We would like to confirm the current consumption of the LSM6DS3USTR while enabling the Accel+ Gyro Mode.

Re: Hello Team, We would like to confirm the current consumption of the LSM6DS3USTR while enabling the Accel+ Gyro Mode.

Re: Hello Team, We would like to confirm the current consumption of the LSM6DS3USTR while enabling the Accel+ Gyro Mode.