HelloI am trying to implement Position control with the latest version 5.4.4 of motor library, but the alignment function never succeeds and this loop has run forever :  while(MC_GetAlignmentStatusMotor1()!=TC_ALIGNMENT_COMPLETED){}I am using quadrat...

Dear,I know that ST Motor control library does not support Absolute encoder, so I am trying with some difficulties to do it, I connected my motor with HALL sensor and also connected my absolute encoder with SPI, I can read the abs position without an...

Dear,It not clear for me, here : In my case Hall sensor are physically spaced by 60 deg, I am not sure how to setup these 2 parameters.Any help appreciated.Regards

DearI am looking to test Nucleo-F401 with Motor driver IHM07-M1 but when stating motor profiler, this nucleo board does not appears in the list of supported board. When reading release not of Motor profiler, F401 should be in the supported board.Plea...