TeseoIII GNSS stops responding after continuous operation of more than a few hours.No NMEA or PPS output. Only GNSS reset resumes operation. This happens on both DR and non DR parts.Attached BIN firmware file. Could you please check, maybe some setti...

When boot configuration is set to boot over UART.How can I use UART0 pins for flashing firmware instead of UART2?The Xloader 2.2 only recognizes UART2 port for initial firmware flashing.

Hi,I am using the suite with a TeseoIII set to output at 230400 baud rate.When in this rate the suite does not auto-detect it and does not connect automatically as it does in 115200.When configured manually to this rate, it can communicate and show t...

Hi,Can I flash a DRAW supporting bin file which is used for STA8089GATD (STA8089_4_7_12_2_BOOT26.bin) on a non DR part (on STA8089GAT)?Thanks,Dror.

I am trying to bringup a new platform with TeseoIII.I manage to flash the firmware, erase etc. However, when using Teseo-Suite, i can see 1-2-3 satellites recognized and a short few seconds after being visible on the Signal level window, they disappe...