About BlueMOSFET

BlueMOSFET · 2021-06-04

I know that the 0xCA 0x53 sequence into RTC->WPR is not needed to write to RTC->ISR (because RTC->ISR is an exception to that 0xCA 0x53 rule) but, is it still needed to set DBP=1 in PWR->CR to write to RTC->ISR?I am not sure if the writability of RT...

BlueMOSFET · 2021-06-01

It does parse global variables in the corresponding .elf file of the same project, compiled in Debug mode (without optimizations). The introductory video (of Cube Monitor) said it can parse debug and release .elf files, but it does not seem to be the...

BlueMOSFET · 2021-06-04

You are right. Thank you.So, to put it clearly, even to just read the RTC calendar (time and date -and in that order, to guarantee consistency with each other-) the right way (doing repeated readings, until the two last ones match), the DBP=1 rule an...

BlueMOSFET · 2021-06-02

Yes, I found it. For STM32CubeIDE, it is in (Project) Properties -> C/C++ Build -> Settings -> (Tab) Tool Settings -> MCU G++ Compiler -> Debugging -> Select configuration "Release" -> Debug level: "Maximum (-g3)".And that is independent on the optim...

BlueMOSFET · 2021-06-02

Why would it be not possible to monitor a global variable of some code that is not optimized? That variable still sits in a defined place, in SRAM, that place is known at the moment of compilation, STM32CubeMonitor could perfectly know where to look ...

User statistics

User Activity

RTC of STM32L072CZ. DBP=1 needed, to write to RTC->ISR?

STM32CubeMonitor 1.2.0 does not parse global variables in .elf files compiled in Release mode (with optimizations). Why?

Re: RTC of STM32L072CZ. DBP=1 needed, to write to RTC->ISR?

Re: STM32CubeMonitor 1.2.0 does not parse global variables in .elf files compiled in Release mode (with optimizations). Why?

Re: STM32CubeMonitor 1.2.0 does not parse global variables in .elf files compiled in Release mode (with optimizations). Why?