About HPERNET

HPERNET · 2021-11-05

I have no problem to flash or debug the CM4 of the board. But when I'm trying to flash the CM0+ this error occurred : Error in final launch sequence:Failed to start GDB serverFailed to start GDB serverError in initializing ST-LINK device.Reason: (255...

HPERNET · 2022-05-13

Hello, Thanks for your anwser (sorry for the long time no responding I just get back on this project...)It works well using STM32CubeIDE V1.8.0 thanks. Do you know when this is going to be fixed on V1.9 ? Best Regards

HPERNET · 2022-05-03

Hello, It's seams that I have the same issue did you find any solution ?Thanks

HPERNET · 2022-03-14

Hi,I still can't flash with stm32 cube ide but I manage to flash it using stm32 programmer by ereasing the memory and program the flash using elf or binary files. You can check my post on stack overflowhttps://stackoverflow.com/questions/71223005/c...

HPERNET · 2021-12-08

Hello, I just try it on a new board with the example code give by ST and I have the same error... I have this configuration : Is anyone have an idea about why I cant flash my MO+ ? Or do you have some ressources that I can use to make my configurati...

HPERNET · 2021-11-05

I just tried to connect those pin like its show on this picture (following the youtube tutoriel of STMicroelctronic https://www.youtube.com/watch?v=bt_A0JO7E_8)

User statistics

User Activity

I can't run or debug my CM0+ with NUCLEO-WL55JC1.

Re: I can't run or debug my CM0+ with NUCLEO-WL55JC1.

Re: Problem of ADC internal voltage regulator in STM32H743IIT

Re: I can't run or debug my CM0+ with NUCLEO-WL55JC1.

Re: I can't run or debug my CM0+ with NUCLEO-WL55JC1.

Re: I can't run or debug my CM0+ with NUCLEO-WL55JC1.