About Rastislav Wartiak

Rastislav Wartiak · 2018-05-09

Posted on May 09, 2018 at 22:22Hello,during my S2-LP Sigfox registrator process, I've sent the generated e-mail to mailto:sigfox@st.com. But the response contained an error:Error while responding to [...].Error Code: 2Message: No more ID in the data...

Rastislav Wartiak · 2018-05-25

Posted on May 25, 2018 at 10:31Thank you for your test, with 0.25°C resolution the temperature sensor can make more sense in some deployments.

Rastislav Wartiak · 2018-05-18

Posted on May 18, 2018 at 19:47I've used it only in low power mode, but my understanding is that the resolution is always in degrees, so you'll need both registers. And I don't have the sensor with me right now.

Rastislav Wartiak · 2018-05-17

Posted on May 17, 2018 at 22:31Thank you, I was able to get the ID/PAC.

Rastislav Wartiak · 2018-05-17

Posted on May 17, 2018 at 22:29Have you also set BDU bit in register CTRL_REG4? Combined with 0xC0 in TEMP_CFG_REG it works for me.OUT_TEMP_L and OUT_TEMP_H contain the offset from 25 degress C. In low-power mode it is enough to use OUT_TEMP_H, only...

Rastislav Wartiak · 2018-05-17

Posted on May 17, 2018 at 22:11When you check the Nucleo board schematics, you'll see two GPIO expanders that control all three XSHUT lines. You need to turn two devices off and one on, change it's address and do the same for another one. The last o...

User statistics

User Activity

S2-LP Sigfox registration

Re: LSM303AGR Temperature Measurements

Re: LSM303AGR Temperature Measurements

Re: S2-LP Sigfox registration

Re: LSM303AGR Temperature Measurements

Re: How to enable Left/Right VL53L1X ranging sensor?