1. Is there a ucf file or setup description for touch or swipe ? 2. The power consumption seems very high for touch and swipe. Using the adapter board and Unico, with just the accelerometer and qvar running at 200hz low power mode, its about 13uA. I...

When I read any of the axis output registers with SPI (OUT_X_L etc), it appears the MISO line is held high after the read. This causes a sustained high power consumption on my CPU after the read. If I read any other register type after reading an out...

Posted on November 17, 2017 at 22:41What is the expected self test difference values that should be expected? The spec indicates between 70 mg  and 1500 mg which seems like a very large range. Most other ST sensors has this value in a few hundred mg...