About ATank.1

ATank.1 · 2024-10-21

Hello I think we can control the reset and boot0 pin of F407 externally through a different board STM32H745 disco. I want to put the F407 in boot mode and send data to program the F405 through UART. Please confirm Thanks & Regards, Anuj

ATank.1 · 2024-10-21

Hello Team,We are developing a bootloader for STM32H745 MCU. Follwoing are requirements, 1. SDcard will contain the images for M7, M4 and External QSPI flash connected to H745 MCU2. Planning to use Secure boot such as SBSFU. Please suggest if this is...

ATank.1 · 2024-10-21

Hello Team,Can you please suggest a development, Evaluation board for STM32F405?ThanksAnuj

ATank.1 · 2024-08-08

Hello,Am using STM32H745XI device same as the disco board and external flash on QSPI (MT25QL512A) single chip flash. IAR IDE is used for development. Though there are reference driver codes available for MT25QL512A but different controller is used. I...

ATank.1 · 2024-06-07

Hello,I wanted to add bluetooth capability to a board with STM32H745 controller. I have a USB port on the board on which I plan to connect a USB bluetooth dongle for bluetooth connectivity.Are there any Development boards and example codes available ...

ATank.1 · 2024-10-21

Hi @SofLit Thank you for the quick response. This is exactly what I was looking for.Regards,Anuj

ATank.1 · 2024-09-05

Hi @Tesla DeLorean ,Thanks for the information. The loader you shared works perfectly so no issues. I was able to confiure the external flash in application project and am able to see the images load in external flash. One difference I observed in ap...

ATank.1 · 2024-08-23

Hello @Tesla DeLorean ,Can you please share source files for the loader?. ThanksAnuj

ATank.1 · 2024-08-22

Hello @Tesla DeLorean,Thanks a lot for sharing the loader.1. The loader is able to program successfully If I directly select the binary and set the address to 0x90000000 and start programming. I read the data and am able to see the data is sucessfull...

ATank.1 · 2024-08-21

Hi @Tesla DeLorean Can you please share a stldr if you already have one as per the configuration above Question: I see lot of different reference codes for MT25QL512 where the instruction is sent over single line or 4 linesDoes it make a difference? ...

User statistics

User Activity

Controlling STM32F407 bootloader (Discovery board) with another board

Secure boot for STM32H745

STM32F405 Development board

External flash Loader STM32H745 + MT25QL512A

STM32H7 with USB Bluetooth Dongle

Re: STM32F405 Development board

Re: External flash Loader STM32H745 + MT25QL512A

Re: External flash Loader STM32H745 + MT25QL512A

Re: External flash Loader STM32H745 + MT25QL512A

Re: External flash Loader STM32H745 + MT25QL512A