FAQs
77kk
Associate II
since ‎2021-10-22
‎2023-06-14

User statistics

  • 6 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

How to change speed of my BLDC motor on ST SPIN 3202 (I can not connect to Motor Pilot)?

2022-05-08
I have an ST SPIN 3202 board and MC Workbench, Motor Pilot both versions 5.Y.3. I opened the example for ST SPIN3202 sensorless six step motor control in MC Workbench and then I generated it in KEIL microvision 5. I changed the parameters for my BLDC...

How to change over current protection for BLDC?

2022-03-25
When I use the example sensorless control for BLDC ST Spin3204 and I connect it to my motor it starts for a bit but then it stops because of over current protection.How can I raise current protection to higher value?I tried to change comparator thres...

How to run an example of the six step algorithm on ST SPIN 3204?

2021-10-27
@Enrico Poli​ I downloaded all the software you sent me Motor Control SDK,Motor Control SDK,Motor Control SDK.Then I opened in motor control workbench the six step sensorles exaple for st spin3204, and generated the code but then I do not know how to...

How do I connect ST SPIN 3204 with six step algorithm properly?

2021-10-26
How do I acces with my ST SPIN 3204 to get programming in C and to connect it properly.I have installed the STM32CUBE PROGRAMMER and there I can connect my board correctly, do I use this aplication?So I would need some help to connect it with the Mot...
Top