About AChin.3

AChin.3 · 2023-02-08

Hello,I am a newcomer to the ST world- I am working with VW of America and UTK on a senior design project.I am attempting to setup a USB-C PD source application using a NUCLEO-G491RE Connected to a SRC1M1 extension board. I have tried directly loadi...

AChin.3 · 2023-03-07

I have tried a google pixel 6 and a Samsung galaxy s8 as my sink devices. If I use the same cable and device on a different USB charger, it works just fine and charges with USB PD. I have been using a DC power supply, so I am sure the voltage going...

AChin.3 · 2023-03-07

Hello,I have figured out why my software was not behaving and am now getting good communication between the board and my UCPD monitor/device. However, I am still not charging my device even though I have powered the CN3 header. I have supplied 20V ...

AChin.3 · 2023-02-10

When I load that program I do not see my device available on ucpd monitor and I do not see anything on any trace - and there is nothing happening when I plug in the device.I did identify a potential issue. I connected a dc power supply to cn3, but I...

AChin.3 · 2023-02-09

During the trace above I did connect a USB-C capable device.

AChin.3 · 2023-02-09

The following is the trace that occurs with my project which followed this wiki.If I load the src1m1 project from x-cube-tcpp by selecting the ioc file in STM32CubeIDE, building it, and running it, I do not get anything in the trace.

User statistics

User Activity

How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?

Re: How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?

Re: How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?

Re: How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?

Re: How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?

Re: How to setup USB-C PD Source using NUCLEO-G491RE with X-NUCLEO-SRC1M1 Extension?