About AGile.2

AGile.2 · 2021-10-26

The problem is that the address of the device is unknown, I tried 0xD4, D5, D6, D7, A6 and many others, zero reaction.To check, I use the function:#define SENSOR_ADDRESS 0xD4if (HAL_I2C_IsDeviceReady(&hi2c1, SENSOR_ADDRESS, 2, 10) == HAL_OK) { HAL...

AGile.2 · 2021-11-14

HI @Eleon BORLINI ,It was possible to connect, my mistake was that I did not apply +3.3V to SDA and SCL.Thanks for the help:)

AGile.2 · 2021-10-28

Hi, I've tried both with no success.I downloaded the library from ST for LSM6DSOX, although it also uses the HAL library, but just in case I use it. The Examples have a code snippet like this:lsm6dsox_device_id_get (& dev_ctx, & whoamI); if (whoamI!...

AGile.2 · 2021-10-27

Hi, thanks for the answer. Most likely the opposite, CS to 1but unfortunately there is still no response from the sensor.Another question arose, should the interrupt be received on the INT2 port or not? maybe this is the problem

User statistics

User Activity

How to connect MKI197V1 to NUCLEO-F756ZGT via I2C but without an expansion board.

Re: How to connect MKI197V1 to NUCLEO-F756ZGT via I2C but without an expansion board.

Re: How to connect MKI197V1 to NUCLEO-F756ZGT via I2C but without an expansion board.

Re: How to connect MKI197V1 to NUCLEO-F756ZGT via I2C but without an expansion board.