About MHawk.1

MHawk.1 · 2021-09-15

I picked the STM32F3 Discovery board because it has 4 ADCs that can supposedly record data at 5MSPS. I am new so a little direction on example code and which pins to use would be great. Im currently trying to be more familiar with the STM32CubeIDE...

MHawk.1 · 2021-09-16

I believe the document you are referring to is the UM1786 titled "Description of STM32F3 HAL and low-layer drivers"? Yes I'm currently trying to up load the programing examples into the IDE. Yes, that's what Ive been told. haha You may be correc...

MHawk.1 · 2021-09-16

yes 5MSPS is alot. That is what the board is capable of at 12 bits, and I think 9MSPS at 6 bits. As i commented on the comment above, the need for the high speed is for recording the sound and vibration travels fast in metal I have steel at about 5...

MHawk.1 · 2021-09-16

lol Sorry for the typo. You are correct I did mean Accelerometers. As far as the user manual, (again I'm new) the attached screenshot Is what I see. Where multiple ADC1, ADC2, Ect associated with multiple pins. Is this the table you are referring...

User statistics

User Activity

I'm extremely new to all of this. My goal is to connect 2 to 4 accelerators to a STM32F3DISCOVERY and record an event based on the rising edge of a signal. Any direction on this is much appreciated.

Re: I'm extremely new to all of this. My goal is to connect 2 to 4 accelerators to a STM32F3DISCOVERY and record an event based on the rising edge of a signal. Any direction on this is much appreciated.

Re: I'm extremely new to all of this. My goal is to connect 2 to 4 accelerators to a STM32F3DISCOVERY and record an event based on the rising edge of a signal. Any direction on this is much appreciated.

Re: I'm extremely new to all of this. My goal is to connect 2 to 4 accelerators to a STM32F3DISCOVERY and record an event based on the rising edge of a signal. Any direction on this is much appreciated.