About Daniele Mereu

Daniele Mereu · 2017-08-01

Posted on August 01, 2017 at 11:56Hi all,I've a problem on STM32F103RET6 microcontroller using the UART1 flow control in combination with the Bluegiga BT121 bluetooth chip. I'm using a custom board with these simple hardware configuration:I'm using ...

Daniele Mereu · 2017-08-02

Posted on August 02, 2017 at 15:15Hi Vangelis,I also found that documentation but it was not helpful for me to solve the problem.But I did a strange discovery: if instead of UART1 I use the UART2 of the microcontroller, then communication works corr...

Daniele Mereu · 2017-08-01

Posted on August 01, 2017 at 16:23Hello Vangelis,DMA RX mode is already circular and also setting baudrate at 115200 it doesn't work.I'm not using BGAPI, but this BGscript:&sharpvariable definitions dim repdim f, p ♯ Boot event listener - Generated ...

Daniele Mereu · 2017-08-01

Posted on August 01, 2017 at 13:35Hi Vangelis,I also tried lower baud rates, for example 115200, 9600, without any positive result

User statistics

User Activity

STM32F103 UART1 flow control + bluetooth BT121

Re: STM32F103 UART1 flow control + bluetooth BT121

Re: STM32F103 UART1 flow control + bluetooth BT121

Re: STM32F103 UART1 flow control + bluetooth BT121