About Saltr.1

Saltr.1 · 2022-05-09

I am using a PN7150 with ISO 15693, and the resulting sequence is :0x00,0x00,0x07, 0x21, 0x30, 0xB6, 0x1D, 0x00, 0xB2, 0x00first 3 bytes written on the nxpNci level, then my message. I want to read some blocks, in particular I would like to read all ...

Saltr.1 · 2021-11-16

I bought a STWBC2-HP and I designed a board as specified in the datasheet, but I can't find any support for the firmware part. Do you have any block code to integrate to a custom firmware to drive the mosfet and implement the WPC protocol?

Saltr.1 · 2022-05-17

Hello, I found the solution. I was missing some bytes. Thank you.

Saltr.1 · 2022-05-16

if I try to read with the Extended read Multiple Blocks, which is :request flags: 8 bits30hUID( when address_flag = 1): 64 bitsfirst block number: 16 bitsNumber of blocks: 16 bitsin my case {0x22, 0x33,0x7C, 0x4A, 0x52, 0x04, 0x00, 0x27, 0x02, 0xE0, ...

Saltr.1 · 2022-05-16

Hello, could you confirm that there is no password or anything to access the memory in raw mode after address 255? If I send this sequence 0x02, 0x30, 0x07, 0xFF, the result is reading block 255, it doesn't read addresses more than 255. Best regard...

Saltr.1 · 2022-05-10

Hello, Do I have to set any particular configuration to have access to the extended commands? The thing is that I can use the read and write for 1 byte using 0x20 and 0x21 as commands, but when I try to use the extension the ST25DV64K-I does not reco...

Saltr.1 · 2021-11-24

ok, if you have a template send it, please. I would like to receive the documentation.

User statistics

User Activity

I need to read multiple blocks of the ST25DV64K-I. What is the command sequence?

Where I can find a code example to run a Qi TX using the STWBC2-HP IC?

Re: I need to read multiple blocks of the ST25DV64K-I. What is the command sequence?

Re: I need to read multiple blocks of the ST25DV64K-I. What is the command sequence?

Re: I need to read multiple blocks of the ST25DV64K-I. What is the command sequence?

Re: I need to read multiple blocks of the ST25DV64K-I. What is the command sequence?

Re: Is there a reference design for the STWBC2 IC?