About BBick.1

BBick.1 · 2020-10-10

I've been trying to get Oversampling working using polling for ADC completion, but I'm not seeing the expected results. I found one example for x4 oversampling, but in reality that doesn't seem to actually be doing anything. I am trying to use 32 f...

BBick.1 · 2020-09-15

BBick.1 · 2020-08-28

Every once in a while when remote debugging I wind up with not being able to set HW breakpoints. There's no clear indication of when this will happen, and I'm typically only setting a single break point. If I disconnect the USB to the STLink V2 fo...

BBick.1 · 2020-08-05

Ubuntu Linux 20.04 and error is Program file does not exist. /home/burtbicksler/ExtraDrive/STM32CubeID/workspace_1.4.0/FD-JUL-MB/Debug\FD-JUL-MB.elf not foundThe elf file DOES exist but it looks like the IDE is putting a backslash after the Debug di...

BBick.1 · 2020-10-13

Thanks for the pointer to the example. When I attempted to use the oversampling configuration I was not getting correct results. Digging into the specs for the 753 MCU we are using I was able to resolve the issue and now get consistent results, and...

BBick.1 · 2020-09-16

Thanks JW, Actually I have it working fine now. I'd missed a setting the proper channel/stream combination for my original testing, so once I worked that out from the working example that was easy to resolve in my original test code.

BBick.1 · 2020-09-16

Thanks JW, I actually followed those steps when I was trying to integrate DMA processing from other examples from the IDE tree, but for whatever reason I couldn't get DMA to work. So I did another pass with the example listed above without trying to...

BBick.1 · 2020-09-16

Thanks TDK. I had actually tried patterning what I was doing after that example. Note that it is for a Nucleo-144 board and not forthe Nucle0-64 F446RE board that I'm working. That said I pulled the code from this example in and had to change the ...

User statistics

User Activity

How to use Oversampling with H753 ADC..

Working example of stm32F446RE ADC for Nucleo board. None is given in the CubeIDE Examples. I have polling working and even interrupt but I haven't had any luck getting DMA working following examples for other F446 boards that do have ADC examples.

Using STLink V2 with openocd sometimes persists HW breakpoints. Is there a quicker way to clear them other than disconnecting the STLink V2 for an extended period of time.

Just getting started with CubeIDE and am working with an existing project, but having an issue with flashing the code to the target.

Re: How to use Oversampling with H753 ADC..

Re: Working example of stm32F446RE ADC for Nucleo board. None is given in the CubeIDE Examples. I have polling working and even interrupt but I haven't had any luck getting DMA working following examples for other F446 boards that do have ADC examples.

Re: Working example of stm32F446RE ADC for Nucleo board. None is given in the CubeIDE Examples. I have polling working and even interrupt but I haven't had any luck getting DMA working following examples for other F446 boards that do have ADC examples.

Re: Working example of stm32F446RE ADC for Nucleo board. None is given in the CubeIDE Examples. I have polling working and even interrupt but I haven't had any luck getting DMA working following examples for other F446 boards that do have ADC examples.