About Maciej Skrzypczak

Maciej Skrzypczak · 2018-02-26

Posted on February 26, 2018 at 14:50Hi,I am having a problem with ADC read. The values I get from conversion are 100% random. They get from 0 to max range without any pattern. Example codes from MXCube work fine and the value is stable. My own code ...

Maciej Skrzypczak · 2017-11-18

Posted on November 19, 2017 at 00:02Hi, I'm using a stm32f767ZI microcontroller on NUCLEO eval board in Keil uVision environment. I have huge problems with my first steps beacause of interrupts handling. I have some questions about it and I didnt fi...

Maciej Skrzypczak · 2018-02-26

Posted on February 26, 2018 at 23:28Ye, I checked and it wasnt the way I expected. After correction the code behaves still the same way (almost full range fluctuatiions). This register was responsible for selecting a channel to measure. I was so des...

Maciej Skrzypczak · 2018-02-26

Posted on February 26, 2018 at 18:28I didnt measure the signal on the oscilloscope but the example project in cube worked with almost no fluctuations. My hand made code returns values that are even 50% off from the expecte value. For example, when I...

Maciej Skrzypczak · 2018-02-26

Posted on February 26, 2018 at 17:51Ye, that was bad... After changing the code ADC still not operating well. Have You got any ideas?

Maciej Skrzypczak · 2018-02-26

Posted on February 26, 2018 at 17:50Thank You for Your reply. I realised now that the code contains some mistakes(not too big). Your solution ended up changing the behavior of ADC, but not solved that. Now instead of getting a value in full range of...

User statistics

User Activity

ADC fluctuations problem

Interrupt first steps problem

Re: ADC fluctuations problem

Re: ADC fluctuations problem

Re: ADC fluctuations problem

Re: ADC fluctuations problem