About MGrub.3

MGrub.3 · 2020-07-30

I am using STM32L476, and I downloaded X-CUBE-EEPROM software package, included it into my project and it works fine. But I am noticing that after every reset it writes dummy word of all 0. CRC + Vaddress +Data... all 32 bits are zeros.That write is ...

MGrub.3 · 2020-07-25

It also doesn’t erase after starting new debug session. Is that expected behavior? I am using STM32L476, and I downloaded X-CUBE-EEPROM software package, included it into my project and it works fine. EEPROM content is retained after NVIC_SystemReset...

MGrub.3 · 2020-07-31

I didn't change code from X-CUBE-EEPROM software package, so EEPROM starts at 0x08080000. The rest of my application is just basic. Not much of flash is taken by the application code which starts at 0x08000000.

MGrub.3 · 2020-07-27

I am using STM32 IDE (Eclipse based) and I can't find Erase All or Mass Erase options, and also any other settings regarding flashing the code to target.I will explore recommended options and decide what works best for me. Thank you all.

MGrub.3 · 2020-07-25

This will not answer your question but I downloaded X-CUBE-EEPROM package and added needed files to my project. It worked well.

User statistics

User Activity

X-CUBE-EEPROM software package, fills in zeros into emulated EEPROM on every reset.

Emulated EEPROM is not erased after flashing new code

Re: X-CUBE-EEPROM software package, fills in zeros into emulated EEPROM on every reset.

Re: Emulated EEPROM is not erased after flashing new code

Re: What's the correct procedure to add the X-CUBE-EEPROM package to SMT32CubeIDE?