About PBitt.1

PBitt.1 · 2020-12-10

Dear ST,I am using an LSM6DSL connected to the SPI pin of AVR (ATMEGA328PB; schematic attached). The SPI line is shared by two other devices with different CS. I am having issues programming the AVR through SPI (raw board, all ICs new, 125kHz SPI cl...

PBitt.1 · 2020-07-30

I could not find this information in the datasheet or app note (just power down, LP, NM, and HP modes).

PBitt.1 · 2020-07-18

PBitt.1 · 2020-07-30

Hi Eleon,Thank you, it is a little confusing as Table 16 provides information on transition times from power down to sleep/active and from sleep to active as different things (and from active accelerometer + gyroscope sleep to others).Section 3.5 sta...

PBitt.1 · 2020-07-21

Dear Eleon,Thank you for the reply.I had not seem the application note. Am I right to say it can take up to 80ms from power down to normal mode? I noticed the time from sleep mode to normal mode is much faster, but I could not find the current consum...

User statistics

User Activity

Possible LSM6DSL conflict in SPI line

What is the LSM6DS3 gyroscope current consumption while in sleep mode?

I need to use the LSM6DS3 at 5Hz and lowest power consumption possible. How long does it takes from power down mode to valid data and back to power down (i.e. how much wake up time does it requires for one point measurement)? Thansk!

Re: What is the LSM6DS3 gyroscope current consumption while in sleep mode?

Re: I need to use the LSM6DS3 at 5Hz and lowest power consumption possible. How long does it takes from power down mode to valid data and back to power down (i.e. how much wake up time does it requires for one point measurement)? Thansk!