About ASank

ASank · 2021-04-28

Hi,I am trying to configure the pin PC13 in my STM32G473VBE6 device as Input with Pull up option.There is a sensor connected to it, so when it is activated it will pull the pin low. But after configuring the pin PC13 to Input with pull up. I am seein...

ASank · 2021-04-12

Hi, I have been trying the Flash dual boot example from version1.3.0. I am following the steps as given in the readme.txt, flashed the bank2 FW from location 0x08040000 and used the debugger to flash the bank1FW. I triggered a bank swap by pressing t...

ASank · 2021-05-06

Thanks for the respoinse.Sorry for the delay, was having a long weekend here. Please find the contents of the registers RTC_CR - COE field is 0TAMTS - 1TAMPOE - 0GPIO registersGPIOC - PUPDR13 - 0x01IDR13 - 1Also now I am no longer seeing that pin wit...

ASank · 2021-04-12

I tried changing the stack pointer size as you mentioned. But same issue. /* Start the Option Bytes programming process */ if (HAL_FLASH_OB_Launch() != HAL_OK) { /* Error occurred while reloading option bytes configuration. User can ad...

ASank · 2021-04-12

Hi Imen,I am currently using CubeIDE 1.5.1. Where do I check for the device rev?I did check the bootloader version based on another message in the group, it was showing D3.I assume must be 13.3. So the HAL_FLASH_OB_Launch() API wont work in bootload...

User statistics

User Activity

Pin PC13 in input mode with pull up option does not drive the pin high.

Hi am using the STM32G474RE nucleo board to try Flash_Dualboot example but crashing at HAL_FLASH_OB_Launch()

Re: Pin PC13 in input mode with pull up option does not drive the pin high.

Re: Hi am using the STM32G474RE nucleo board to try Flash_Dualboot example but crashing at HAL_FLASH_OB_Launch()

Re: Hi am using the STM32G474RE nucleo board to try Flash_Dualboot example but crashing at HAL_FLASH_OB_Launch()