About MBjel.1

MBjel.1 · 2020-07-09

I have already tried to use a second SystemClock_Config (copied from a fresh project after code generation), to first use the HSI after reboot and initialize everything (USART, GPIO,...), and then switch to the HSE, but it didn't work.I would appreci...

MBjel.1 · 2020-07-16

Hi Clive, sorry for my late reply."Does nothing" means here that after rebooting, I'm not able to communicate with the controller via UART. It just sends zeros (0x00) for ca. 10 seconds and then stops."Didn't work" means, that the controller still ru...

MBjel.1 · 2020-07-09

Yes, it's my own board design.BOOT0 shouldn't be the problem, everything works perfectly fine when i choose HSI as the clock source.I have to admit that I'm relatively new to this community, so I'm not sure what exactly you mean with Error Handler/ H...

User statistics

User Activity

Hello everybody, I'm trying to program an STM32F446RCT6. It should run from HSE, which works fine after loading the program on the chip, but after rebooting (switching the voltage source off and on) it does nothing.

Re: Hello everybody, I'm trying to program an STM32F446RCT6. It should run from HSE, which works fine after loading the program on the chip, but after rebooting (switching the voltage source off and on) it does nothing.

Re: Hello everybody, I'm trying to program an STM32F446RCT6. It should run from HSE, which works fine after loading the program on the chip, but after rebooting (switching the voltage source off and on) it does nothing.