About DTorn.1

DTorn.1 · 2022-06-14

One of the variint main(void){ /* USER CODE BEGIN 1 */ /* USER CODE END 1 */ /* MCU Configuration--------------------------------------------------------*/ /* Reset of all peripherals, Initializes the Flash interface and the Systick. */ HAL_Init(); /...

DTorn.1 · 2022-07-06

Thanks for the support! I have solved the problem! The code is correct, the payment is in order.

DTorn.1 · 2022-06-24

There are no jumpers! Have I answered all the questions?

DTorn.1 · 2022-06-24

And it works in high/low mode! But there is no DAC signal.

DTorn.1 · 2022-06-24

Yes! Of course, PA4 is connected directly to A2. Excuse me!

DTorn.1 · 2022-06-23

Pin P4 without DAC reproduces the signal in OUTPUT mode

User statistics

User Activity

Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you

Re: Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you

Re: Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you

Re: Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you

Re: Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you

Re: Hello! I purchased the STM32G431RBT-Nucleo board. When trying to write code to control the DAC, I ran into a problem - regardless of the code change, the result is 0v, there is a straight line on the oscilloscope. The code itself runs on STM32F407. Do you