About NN.2

NN.2 · 2022-06-10

STM32CubeIDE Version: 1.9.0Hal MCU : v1.5.1Chip: STM32G061C8U6 If you enable USART1 in asynchronous mode for pins PA9 and PA10 the auto generated code incorrectly sets the port to AF0 when it should be AF1 see datasheet table 13 or port.png.When set ...

NN.2 · 2022-06-22

@Sara BEN HADJ YAHYA Were you able to replicate the issue on your end? Any further progress?

NN.2 · 2022-06-14

The issue has been fixed. Two things need to be added.The GPIO alternative function goes to the wrong port./* USER CODE BEGIN USART1_MspInit 0 */ GPIO_InitStruct.Alternate = GPIO_AF1_USART1; // Auto generated code is wrong /* USER CODE END USART1_...

NN.2 · 2022-06-10

There is no I2C enabled.

NN.2 · 2022-06-10

I have these configured as GPIO outputs and these work as expected.I tried creating a brand new project with just UART1 enabled and I get the same behaviour.Under the SYS menu Use PA9 instead of PA11 and PA10 instead of PA12 is disabled.

User statistics

User Activity

STM32G061C8U6 UART Generated Config is Incorrect

Re: STM32G061C8U6 UART Generated Config is Incorrect

Re: STM32G061C8U6 UART Generated Config is Incorrect

Re: STM32G061C8U6 UART Generated Config is Incorrect

Re: STM32G061C8U6 UART Generated Config is Incorrect