About LIUJINGJING

LIUJINGJING · 2022-05-27

I want to use Nucleo-G431RB and X-Nucleo-IHM08M1 3Sh to control a outer rotor BLDC with FOC. Now I am confusing how to set jumpers.In the introduction of Motor Profile:However, in the Quick Start Guide and User Manual of X-Nucleo-IHM08M1 3Sh ,the req...

LIUJINGJING · 2022-06-01

Because in the Motor Profiler setting, R181 need to be removed. If I remove it, I think I cannot make it on again. And Jumper J9 is off, but I am using the 44V DC supply, according to the AN5464, if the voltage is larger than 12V, J9 must be on.

LIUJINGJING · 2022-06-01

I used the FOC & 3 shunt setting in the parameters estimate in Motor Profiler. Will it influence the eastimate results?

User statistics

User Activity

How to set jumpers of X-NUCLEO-IHM08M1 for FOC control?

Re: How to set jumpers of X-NUCLEO-IHM08M1 for FOC control?

Re: How to set jumpers of X-NUCLEO-IHM08M1 for FOC control?