About DN_1

DN_1 · 2021-05-30

Hi Everyone, I am pretty new to working with a GNSS so please excuse my ignorance on some of these topics.I have been trying to find ways to check if I have a 3D fix or not so I tried to do this by disabling the 2D fix on "CDB-ID 222 – LMS operating ...

DN_1 · 2021-01-30

I am currently interfacing the LPS22HH component and have been encountering some very strange pressure data.Currently I am interfacing this in I2C mode and reading the pressure sensor values from PRESS_OUT_XL (28h), PRESS_OUT_L (29h) and PRESS_OUT_H ...

DN_1 · 2020-07-05

Hi could I find out if anyone has successfully got X-CUBE-SBSFU running on the dual core components? There does not seem to be any examples from ST for these use cases.The dual core components I am aware of are H745/755, and H747/757. However all of...

DN_1 · 2020-06-25

Hello, I am looking to port one the examples from X-CUBE-SBSFU to get it running on my Nucleo H745ZI-Q. For some background I am very new to the world of STM32 and STM32Cube and I am trying to learn to get this feature running on this nucleo board I ...

DN_1 · 2021-05-30

Hi there,Thanks for your quick reply and that link.I was using the Teseo Liv3f software manual from: https://www.st.com/resource/en/user_manual/dm00398983-teseoliv3-gnss-module--software-manual-stmicroelectronics.pdf which I did not explicitly see th...

DN_1 · 2021-05-30

GPGLL message needs to be enabled as it is not enabled by default.GPRMC should be enabled by default, nonetheless you could send the command to enable it just to be sure.

DN_1 · 2021-05-30

Hi there,I have also started recently working with the Teseo and have encountered this behaviour when I trigger a cold start.Alternatively I found a setting on in the software manual "CDB-ID 222 – LMS operating mode setting 1" where it looks like you...

DN_1 · 2020-07-22

In fact that was what I did, what I didnt do was resize the popup before I closed it :grinning_face_with_sweat: .

DN_1 · 2020-07-22

Update 23/07/2020: I was able to run it in debug again, for some reason debug configurations changed and was setup incorrectly.---------------------------------------------------------------------------------------------------------------------------...

User statistics

User Activity

Disabling 2D fix on TESEO LIV3F

LPS22HH reporting inaccurate raw pressure values

SBSFU on Dual Core STM32 Microcontrollers

Porting of X-Cube-SBSFU to Nucleo H745

Re: Disabling 2D fix on TESEO LIV3F

Re: Hi everyone, Here, Present am Working on TESEO-LIV3F gps interface am Trying to read GPRMC and GPGLL through USART interface,

Re: Teseo liv3F uses 3 satellites but does not get a position

Re: Porting of X-Cube-SBSFU to Nucleo H745

Re: Porting of X-Cube-SBSFU to Nucleo H745