About Abdra

Abdra · 2022-05-11

Abdra · 2022-05-12

I've realized that was a dumb question... I opened the project with CubeIDE. Thanks a lot!

Abdra · 2022-05-12

In the STM32CubeMX I click "File -> New project", choose the board(STM32F302R8). Then I click generate code, enter the project path and project name, and click generate code again. After the code is generated, the following window pops up.I click "Op...

User statistics

User Activity

I can't open the .project file after a click "generate code" in .ioc file. "not a valid ioc file" pops up. What might be the issue?

Re: I can't open the .project file after a click "generate code" in .ioc file. "not a valid ioc file" pops up. What might be the issue?

Re: I can't open the .project file after a click "generate code" in .ioc file. "not a valid ioc file" pops up. What might be the issue?