About Alexandre Bouillot

Alexandre Bouillot · 2017-02-21

Posted on February 21, 2017 at 11:13The setup consist of a STM32l152RE Nucleo board, with a LoRa transciever. The code base is the LoRaMac code from Semtech on Github - SensorNode version, as this is targeting sx1276. The IDE I use is Keil uVision v...

Alexandre Bouillot · 2017-01-21

Posted on January 21, 2017 at 19:42I'm trying to get familiar with CubeMX and STM32 development process and I'm a bit puzzled with the L1 Discovery.To do so, I'm trying to 're-create' the demonstration FW shipped with the board using CubeMX.When cre...

Alexandre Bouillot · 2017-02-27

Posted on February 27, 2017 at 18:05 Hi Joly.Jeanne, rebuild the project has already been done :-). What I was asking is recreate it - i.e. make the 'same' program but using the CubmeMX toolchain. I am under the impression the example is quite ...

Alexandre Bouillot · 2017-02-21

Posted on February 21, 2017 at 16:41I change target MCU from L152RB to L152RE, then build all and run the program.The code rely on RTC alarm to raise an IRQ. The IRQ handler is called once, but not subsequently.I guess there is some configuration ch...

Alexandre Bouillot · 2017-02-21

Posted on February 21, 2017 at 11:06Hi Eric,In order to better understand CubeMX, I was planning to recreate a known code for the L152 Discovery board. The only code I have for this target is the example code running on it. I was therefore planning ...

Alexandre Bouillot · 2017-01-23

Posted on January 23, 2017 at 16:04The device I use is the L1 Discovery with L152RC chip. The CubeMX version is the latest v4190. The STM32CubeL1 library is version 1.6.0.I want to migrate the L1 Discovery FW demo code to CubeMX environment. I there...

User statistics

User Activity

Move from STM32L152R8 to STM32L152RE

CubeMx and Discovery L1

Re: CubeMx and Discovery L1

Re: Move from STM32L152R8 to STM32L152RE

Re: CubeMx and Discovery L1

Re: CubeMx and Discovery L1