About GLeje.2

GLeje.2 · 2024-01-04

Hello,I am currently working on a project involving transferring data acquired with an ADC through ethernet.Im am using the STM32H743 MCU.I have been building small projects using LWIP, and was able to connect to the board, ping and transmit some arr...

GLeje.2 · 2022-11-21

GLeje.2 · 2024-01-05

"Enabled" means i simply enabled the ADC in the CubeIDE configuration panel. I uploaded a picture of my config below so you can see. I indeed suspect there is something wrong with my setup but cannot pinpoint it.I managed to make the ADC module work ...

GLeje.2 · 2024-01-04

It is a regular conversion triggered by software, I should not even be launching conversions at this point.I disabled ADC interrupts for the moment.

User statistics

User Activity

NUCLEO H743, troubles with ADC and LWIP

I am currently designing with the LM119 dual comparator. While simulating my designs i noticed that the Spice model provided by ST for this IC is incorrect. The Gnd pin is missing and it completely changes its behavior. Is there any way to fix the model?

Re: NUCLEO H743, troubles with ADC and LWIP

Re: NUCLEO H743, troubles with ADC and LWIP